TROY Group Hewlett-Packard LaserJet 401 series Font Card Kit User’s Guide - Manual (Page 35)

Appendix A Installing the TROY Font Card
TROY M401 Printer and M401 Font Card Kit User’s Guide -- Document #50-70911-002 Rev. A
A-1
Figure 2
Installing the
TROY Font Card
IMPORTANT: Ensure the printer power is switched OFF, and then
disconnect the printer power cord from the printer.
1. Ensure the printer power is switched OFF. Never install or remove
the Card when the printer power is ON.
2. Open the Card access door at the left side of the printer using your
finger to press and unlatch the door .
3. Detach the Card access door from the printer by fully opening the
door and then unhooking the two hinge tabs from the printer panel.
4. Remove the TROY Font Card from the protective anti-static bag.
IMPORTANT: To prevent static discharge from damaging the TROY Font
Card, handle the Card by the edges .
5. Insert the Card into the Card slot by aligning the notch on back of Card. The
Card can only be inserted in one orientation.
6. Ensure the Card is fully inserted into the Card socket, and then carefully
press on top and bottom of the Card.
7. Replace the access door by aligning the hinge tabs with the notches in the
printer panel, and then push the access door closed until it snaps into place.
8. Reconnect the printer power cord, and then
switch the printer power ON.
9. Refer to the installation instructions found
at http://www.troygroup.com/support for installing the TROY support files on your computer. If assistance is
required, call TROY Technical Support at (855) 889-1109. Customers outside the United States, please call
(304) 232-0899.