Spicer Wheel Differential Bearing Replacement Process - Manual (Page 8)

35. Torque carrier to housing capscrews to the chart below.
Axle Location Dana Kit Part Number Fastener Type N.m Ibs-ft
Forward 512896 Capscrew and Nut 338 - 393 250 - 290
Rear - Rear 512897 Capscrew and Nut 338 - 393 250 - 290
36. Clean axle shaft flanges and wheel hub surfaces and install new axle shaft gasket.
37. Reinstall the axle shaft, washers and nuts, torque to spec.
38. Reconnect IAD shift cylinder and/or wheel diff. lock air line.
39. Reinstall the driveline.
40. Remove fill plug from housing cover and refill the housing using the same lubricant that was removed. If needed,
add lube and fill until level with the bottom of the fill hole.
For spec’ing or service assistance, call 1-800-
24 hours a day, 7 days a week.
Or visit our web site at: http://www.
VSLFHUSDUWV.com
Dana Corporation
SHAIS183A Copyright Dana Corporation, 2008 Heavy Vehicle Technologies and Systems Service
June 2008 All Rights Reserved. P.O. Box
Printed in U.S.A. www.dana.com Toledo, Ohio 43697-0321