Spicer Wheel Differential Bearing Replacement Process - Manual (Page 2)

9. Now remove the carrier cap capscrews and carrier caps from the plain half and flange half sides.
10. Using the wheel diff. bearing adjustment tool, remove the wheel diff. assembly from the carrier.
Note: The bearing adjustment tool is made up of a threaded rod, two nuts, two washers and two adjustment plates.
Fit one adjustment plate to the plain half threaded cup. Fit the other adjustment plate to the flange half cup. The
adjustment rings will fit into slots of the threaded bearing cups stamped adjustment ring.
11. Connect the adjuster plates using the threaded rod, washers and nuts. Tighten the nuts on the rod to hold the
threaded cups in place. Carefully raise the hoist to remove the wheel differential and ring gear assembly from the
carrier.