Philips SCD525 - Manual (Page 14)

14
7.10 Reset function
This function in the menu of the parent unit
allows you to reset both the parent unit and the
baby unit to the default settings at the same time.
You can use this function if problems occur that
you cannot solve by following the suggestions
in chapter ‘Frequently asked questions’.
1
Select ‘Settings’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Reset’ with the + and - buttons.
4
Press the OK button to confirm.
• The message ‘Confirm?’ appears on the
display of the parent unit.
5
Press the OK button to confirm.
• The parent unit switches off and then
switches on again.
• The units have now both been reset to the
default factory settings.
7.10.1 Default settings
Parent unit
• Language: English
• Loudspeaker volume: 1
• Microphone sensitivity: 5
• Sound alert: off
• Temperature alert: off
• ‘Temperature low’ alert: 14°C
• ‘Temperature high’ alert: 35°C
• Temperature scale: Celsius
• ECO mode: off
Baby unit
• Loudspeaker volume: 3
• Nightlight: off
• Lullaby: off
7.8 Temperature alert on/off
D Note:
You can only switch the temperature alert on and
off in the menu of the parent unit.
D Note:
If the temperature alert is activated too often,
reduce the set minimum temperature and/or
increase the set maximum temperature (see
‘Setting room temperature range’).
If the temperature alert is switched on, the
parent unit beeps if the actual room temperature
exceeds the set maximum temperature or drops
below the set minimum temperature. In addition,
the backlight of the parent unit display goes on
and ‘High’ or ‘Low’ appears on the display. If no
minimum and maximum temperatures have been
set, the temperature alert is given when the room
temperature drops below 14°C or rises above
35°C.
1
Select ‘Temperature’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Alert’ with the + and - buttons.
4
Press the OK button to confirm.
5
If the alert is off, the display shows ‘On?’. Press
the OK button to switch on the alert. If the
alert is on, the display shows ‘Off?’. Press the
OK button to switch off the alert.
7.9 Setting temperature scale
D Note:
You can only set the temperature scale in the
menu of the parent unit.
You can set the temperature scale either to
Celsius (C) or Fahrenheit (F).
1
Select ‘Settings’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Temp scale’ with the + and - buttons.
4
Press the OK button to confirm.
5
Select ‘Celsius’ or ‘Fahrenheit’ with the +
and - buttons.