Philips SCD525 - Manual (Page 11)

11
7 Menu options
All functions can be operated on the parent unit,
but some functions can also be operated on the
baby unit.
7.1 Menu operation - general
explanation
D Note:
Menu functions can only be operated when a
connection has been established between the
baby unit and the parent unit.
1
Press the MENU button to open the
menu (Fig. 28).
• The first menu option appears on the
display.
2
Use the – and + buttons to select the desired
menu option (Fig. 29).
D Note:
The arrow indicates in which direction you
can navigate.
3
Press the OK button to confirm (Fig. 30).
4
Use the + and - buttons to select the desired
setting.
5
Press the OK button to confirm.
• The new setting flashes once. The message
‘saved’ also flashes once and then
disappears from the display.
6
Press the MENU button again to exit the
menu.
7.2 ECO mode
D Note:
You can only switch the ECO mode on and off
in the menu of the parent unit.
You can use the ECO mode to reduce the energy
consumption of the appliance. Monitoring your
baby from a small distance requires less
transmission power and less electrical power
than monitoring your baby from a large distance.
When you monitor your baby from a small
distance, you can activate the ECO mode.
6.6 Lullaby function
D Note:
You can also operate the lullaby function in the
menu of the parent unit (see chapter ‘Menu
options’, section ‘Lullaby function’).
1
Press the play/stop button E on the
baby unit to play the currently selected
lullaby. (Fig. 26)
• The lullaby starts to play and repeats
continuously.
2
To select another lullaby when a lullaby is
playing: (Fig. 27)
• Press the lullaby button K on the baby
unit.
• Wait 2 seconds for the next lullaby to
start.
• If you want another lullaby, press the
lullaby button K on the baby unit again.
3
To stop the lullaby, press the play/stop button
E on the baby unit again. (Fig. 26)
6.7 Out of range alert
When the parent unit is out of range of the baby
unit, the parent unit beeps from time to time and
the messages ‘Searching’ and ‘Not linked’ appear
on the display. The LINK light on the parent unit
flashes red.
D Note:
The message ‘Not Linked’ also appears on the
display of the parent unit when the baby unit is
switched off.
ENGLISH