Hotchkis 22801 Audi B5 Sport Sway Bar Set - Manual (Page 6)

5/
Apply a quarter tube of grease to each inner portion of
the two new front bushings and attach to HSport bar against the outside of the
washers on the bar. Slip the new brackets over the bushings.
6/
Lift the bar up to the vehicle. The two smaller HSport stickers at the bar’s
ends should be right-side-up. As you lift the bar up to the mounting points, you
must place one mounting plate per side between the bushing and the
mounting point. This relocates the bushing out of the stock bushing pocket.
7/
Re-install the bracket nuts and tighten. Apply Blue threadlocker to the end
link bolts and tighten well. **Note** If vehicle is raised using jack stands or
other, the bar end and the end link may not align properly. Lower vehicle
so that front suspension is not at full droop and ends will align. Be sure to
thread end link bolt by hand at first to prevent cross-threading.
8/
Re-install the aero pan.