beautypg.com

Hotchkis 22801 Audi B5 Sport Sway Bar Set User Manual

Page 2

background image




4/

Remove the four bracket bolts and nuts. Slowly remove the bar by rolling

it over the exhaust. WAIT TO INSTALL HSPORT BAR.













5/

Now install the reinforcement brackets. The driver’s side frame has two

holes above the rear portion of the lower a-arm. Use the flange-headed bolts
and place the head on the inside of the frame facing out. Take the black bracket
marked ‘D’ and place it up against frame as shown. The ‘D’ sticker will end up
against the frame, with the gusset towards the ground. Use the lock washers
and lock nuts provided. Assemble with 14mm wrenches and leave loose, DO
NOT TIGHTEN
.












6/

Take one of the supplied billet pieces and remove one of the bolts. This

allows you to open the piece and slide over the driver’s side toe link. Reattach
the bolt and washer (13mm wrench) with the HSport sticker pointing towards
the outside of the vehicle and tighten both bolts
. You may angle the brace
up against the toe link itself to get enough leverage to tighten the bolts