Hotchkis 22801 Audi B5 Sport Sway Bar Set - Manual

B5 Audi S4/A4
#22801
Front and Rear Anti-Roll Bar Kit Installation
Instructions
Tools
Required: Included In Kit:
1/ 4-wheel lift/ramps or jack stands
1/ front and rear anti-roll bars
2/ 13mm socket 2/ 4 bushings & 4 brackets
3/ 13mm wrench 3/ 2 front bushing mounting plates
4/ (2) 16mm wrenches 4/ reinforcement bracket kit
5/ 5mm allen 5/ hardware kit
6/ (2) 14mm wrenches 6/ 1 grease pack
7/ Blue Locktight
START WITH THE REAR BAR/REINFORCEMENT BRACKETS.
1/
Raise vehicle using a 4-wheel lift, drive-on ramps or jack stands at the
proper jack points. When using jack stands, always utilize a level surface.
2/
Once vehicle is raised, take a moment and observe the stock rear bar
and the way in which it is mounted.
3/
Rear bar can be removed and installed without releasing exhaust but
detach if necessary at rear. Remove the two lower end link nuts (16mm wrench)
which may require holding the stud steady with the 5mm allen.