High Lifter Lift Kit for Honda Rubicon 500 (01-13) - Signature Series - Manual (Page 5)

Rear Lift Installation
1)
Place jack under ATV at the rear of the bottom engine skid plate (not the differential), and lift until
the weight is off of the suspension. Be careful to secure the ATV properly so as not to fall off the
jack.
2)
After removing the bottom of the shocks, jack the ATV up an additional 1”-2”.
3)
Remove two factory nuts from the rear. One from the left side of the differential and the other is to
the right of the differential.
4)
Next connect the Large Rear Lift Bracket and Small Rear Lift Bracket to the rear shock mounts.
Using the stock bolt that connected the shock to the frame, connect the bracket to the frame. Place
the Small Spacer between the shock mount tab and Large Lift Bracket. To the outside of the shock
mount tab use the Small Rear Lift Bracket. NOTE: The cut out on the small bracket clears the
shock tab.