High Lifter Lift Kit for Kawasaki Brute Force 750i - Signature Series - Manual (Page 3)

3
Installation Instructions
1) Place jack under center of ATV front end and lift until front wheels clear the ground. Be careful to
support ATV properly so that it is securely supported but so that A-arms and shocks can droop to
full extension.
2) Remove front wheels.
3) Disconnect the top of the shock from the shock mount.
4) Slide the long front lift bracket next to the frame. It should run from one shock mount to the other,
on the front side.
5) Next place the spacer in the shock mount tab loosely securing it with the small lift bracket and 10x65
bolt and 10mm lock nut.
6) Now connect the top of the shock to the lift brackets using (2) flat 10mm washer, 10x65 hex bolt
and 10mm lock nut. Place the washers on either side of the shock eyelet.