High Lifter Lift Kit for Arctic Cat 700 - Manual (Page 3)

Front Lift Installation Instructions
1. Place the jack under the center of the ATV front end until front wheels clear the ground. Be careful to
support ATV properly so that it is secure, but so that the A-arms and shocks can droop to full extension.
2. Remove front wheels and bottom of the shock.
3. Place the Large spacer on the inside of the lower shock mount, placing the Front Square Tube Bracket,
with the notch down and facing inward, and open end down and outwards, over the shock mount.
Secure this bracket with a 10x50mm bolt and a 10mm nut that’s provided with the kit.
4. Place the bottom of the shock inside the top of the Front Square Tube Bracket and placing one Small
Spacer between the front of the shock and the Tube Bracket.
5. Next, place the Flat Bracket (Long) on the rear and to the outside of the Tube Bracket. Securing it with
a 10x50mm Hex Head Bolt and 10mm Lock Nut.
Note: The angle of the bracket should extend rearward.
6. Secure the Flat Bracket (Long) to the rear of the A-arm and the Flat Bracket (Small) on the front of the
A-arm with two
1”x1 ¾ Hex Head Bolts, and secure it with two ¼” Lock Nut. Before tightening all nuts, ensure the
angle of the shock is at the same original angle.
7. Tighten all bolts. Repeat this procedure for the other side.
8. On the bottom a-arm you need to remove and reverse the bolt to clearance the front CV shaft. If you do
not reverse the bolt you will have the CV shaft rubbing on the lock nut and bolt.
3