High Lifter Lift Kit for Honda Foreman 450 (02-04) - Manual (Page 5)

Right Side
1) Place bracket “J” on the right outside of the shock mount (notch up).
2) Place spacer “E” on the inside of the shock mount.
3) Place bracket “I” between spacer “E” and the inside of the shock mount, (to the left of spacer “E”
and to the right of the inside wall of the shock mount).
4) Secure this with the stock OEM bolt.
5) Place bottom of shock (bottom shock eyelet) between brackets “J” and bracket “I”, securing this
with a 10x55mm Bolt. Install bolt from right to left.
6) Place end of bracket “H” to the differential housing using the OEM bolt.
7) Tighten all bolts to manufacturer’s torque specifications, on BOTH THE LEFT AND
RIGHT SHOCK MOUNT!
8) Note: Extra 10mm Washers are provided in case there is slack between the shock eyelet and any
of the brackets. Discard any remaining washers.
Both Sides
‰
Tighten all bolts to manufacturer’s torque specifications.
‰
Lower and remove jack.
‰
Check for clearance problems or misalignment.
Right Rear Installation Diagram
1 2
J E J
Notch Up Notch Up
3 4
I E J I E J
Notch Up H Notch Up