High Lifter FLOORBOARD KIT- SUZUKI 700 KING QUAD 2005-2007 ONLY - Manual (Page 2)

2
Installation
1.
Remove the plastic floorboards from both sides of the ATV.
2.
Place the support bracket next to the frame and using a marker, mark the location where the
bolthole will be drilled into the frame to connect the kit to the ATV.
3.
Next, using a 3/8” drill bit, drill the holes into the frame in the marked locations.
4.
Once the holes are drilled, connect the support brackets to the frame using 8mm x 40mm hex
head bolts, 8mm washers and 8mm lock nuts provides in the kit. Make sure to use the washers
on either side of the support bracket.