High Lifter Lift Kit for Honda Rancher 420 SRA Only (07-13) - Manual (Page 5)

Rear Lift
1) Place jack under ATV at the rear of the bottom skid plate and lift until the weight is off of the
suspension. Be careful to secure the ATV properly so as not to fall off the jack.
2) Remove the bottom of the shock from the shock mount.
3) After removing the shock, jack the ATV up 1”-2” further.
4) Attach the Large Spacer and two rear lift rackets to the stock shock location using the 10x70 Hex
Bolt and 10mm Lock Nut.
5) Remove the stock nut that is located on the final driven gear.
6) Next, connect the bottom of the shock to the lift brackets using a 10x70 Hex Bolt.
7) Attach the rear support bracket to the outside of the lift bracket and the final driven gear. Use the
10mm Lock Nut to secure the brackets and shock. Use the stock nut to secure the support bracket to
the final driven gear.
8) When complete reattach wheels torque all lugs to factory specks and lower ATV.
5