EVS Xsquare Version 1.0 - July 2012 User Manual - Manual (Page 20)

Issue 1.0.C Xsquare – Version 1.0 – User Manual
EVS Broadcast Equipment – June 2012
14
Scanfolder ID
You can define here how Xsquare must manage the media IDs (VarID, MaterialID, UmID)
created by the scanfolder
5.3.3 ScanXML Instructions
ScanXML Definition
You can create here ScanXML for previous job xml V1. Xsquare will in fact use the
information of the job V1 + the information defined in the template and then create a full
job.
For each ScanXML you will have to define:
• The source folder: UNC Path where the Xsquare ScanXML will wait for XML job V1
(from IPD for example).
Warning
You cannot create two scanXMLs in the same folder.
The scanXML source must be a shared folder on the network (UNC Path) and
the scanXML service must have Read/Write access on it.
• Template: template with all the job parameters.
Note
If you select No template: Xsquare will simply translate the job V1 to job V2.
• Icon: icon which represents the target.
• Description(s): short description for each destination
• Destination(s): path or IP address.