EVS Xsquare Version 1.0 - July 2012 User Manual - Manual (Page 19)

Xsquare – Version 1.0 – User Manual
EVS Broadcast Equipment – June 2012
Issue 1.0.C
13
Scanfolder Options
You can define here some options for each scanfolder:
Scan Mode
• Uncompleted files + delay (sec): the Scanfolder service will send the job to Xsquare
as soon as it sees the new file or after x seconds, depending on the delay
configuration. In this case, if the source file is not growing compatible, the job will fail.
• Completed files + delay (sec): The Scanfolder service will wait to have Write access
on the file and will also wait x seconds after the last file update before sending the job
to Xsquare.
Orchestration
• Max. Jobs per scan: It is the maximum number of files that the Scanfolder service can
process at the same time.
Note
If you want to be sure that the local XTAccess of your source watch folder will
execute the job, you will have to create a specific cluster for this folder (see
below).
Post- Processing of the Source(s)
• Move to ScanFolder.DONE subfolder (default value): the Scanfolder service will send
a job to Xsquare asking XTAccess to move the source file to a subfolder called
“ScanFolder.Done” if the job is successful or “ScanFolder.Failed” if the job is
unsuccessful.
• Move to specific folder: the Scanfolder service will send a job to Xsquare asking
XTAccess to move the source file in the defined folder after the processing of the
source file.
• Delete source file: the Scan Folder service will delete the source file after its
processing.