EVS IP2Archive Deep Archive Manager Version 3.0 - October 2012 User Manual - Manual (Page 99)

How to Add a Tape Range
To add a range of tapes, proceed as follows:
1. Click the Add button.
• If tape set ID 0 is selected, a warning message appears. This is because normally no
tapes are assigned to tape set 0.
Click No to abort the operation and select a different tape set ID first.
• If tape set ID 0 is not selected, or if you click Yes, the Add Tapes dialog box appears.
2. Select the Tape Range radio button.
3. In the Prefix field, enter the default prefix that should be added to each tape ID
belonging to the tape range, e.g. ‘T’.
A preview is given of the new tape IDs.
4. In the Start field, select or type the start number of the first tape ID.
5. In the End field, select the end number of the last tape ID.
6. In the Length field, specify the length, i.e. the number of characters, of the tape ID.
7. Click the Add button to add the tape IDs or Cancel to cancel the operation.
92 6. Configuring the Application
EVS Broadcast Equipment S.A. - October 2012 Issue 3.0.D