Caution – Concord ULTIMAX ISOFIX INSTRUCTION MANUAL User Manual
Page 7
27
26
CLiCK
In vehicles with series-standard
headrests, a readjustment of the
headrest or its removal will allow
a better mounting position of the
car seat.
Please remember to readjust or
replace the headrest in the
correct position if an adult is to
sit in that place instead.
Push the release button (
09
) outward and position the
support leg (
10
) so that it rests securely on the floor
and the safety display shows GREEN.
Release the control button (
09
) to lock the support leg
in place.
CAUTION!
• The seat must be secured with the
ISOFIX SYSTEM even if no child is
travelling!
• Both ISOFIX adapters (
15
) must be
locked securely in place and the safety
displays (
14
) on both adapters must
show green.
• The support leg (
10
) must rest securely
on the floor and be locked into place.
Turn the ISOFIX SYSTEM (
08
) control dial to the right until the
CONCORD ULTIMAX lies as close/flush as possible to the back
rest of the car seat.
CAUTION!
• Make sure that the seat is correctly
anchored to both anchoring points and the
safety display (
07
) is green!
• The seat is only allowed to be used in a
backwards position if it is upright!
• If the child‘s bodyweight exceeds 8 kg,
the pre-installed pelvic insert should be
removed (see „REMOVING THE PELVIC
INSERT“).
_ mOUnTing THE SEAT OPPOSiTE TO THE DRiVing DiRECTiOn
(FROm BiRTH TO 13 Kg)
CAUTION!
Do not use on seats with airbags.
Danger to life!
Always mount the seat without
a child in it!
Guide the seat (
a
) as shown,
opposite to the driving direction
over the base (
B
).
First mount the frame of the seat
into the seat lock (
12
) of the
ISOFIX base.
Then fold the seat forward until the
front seat lock (
11
) audibly locks
into the ISOFIX base and the safety
display (
07
) on the top is green.