AASTRA 4147 Medium for MX-ONE (TSE) User Guide EN - Manual (Page 61)

61 Dialog 4106 Basic/Dialog 4147 Medium
Settings
Programming the ring signal
By programming, you can adjust the ring character and ring
volume. To change the ring character and volume, you have to
enter the programming mode.
Programming the ring character and ring volume for the
Dialog 4106 Basic
The ring character can be adjusted with three different characters,
each with another three volume levels. u
Lift the handset.
Wait for the dial tone. ¥
Press. #
Press.
z
Select and enter digit from the table below.
Notes:
Default setting is digit 6. If you choose 0, the ring signal will
be turned off until the next time you go off hook.
Please note also that you will not hear the ring signal during
programming. ¥
Press.
The selected ring character is stored. d
Replace the handset to finish the procedure.
Digit (character)
Ring character -
Repetition rate Ring volume
1 1 time Soft
2 1 time Medium
3 1 time Loud
4 4 times Soft
5 4 times Medium
6 (default) 4 times Loud
7 10 times Soft
8 10 times Medium
9 10 times Loud
0 None Off