Dell OptiPlex FX160 - Manual (Page 9)

Dell OptiPlex FX160 Re-Imaging Guide
9
c If the drive is mounted, unmount the drive:
umount
where is the device name of the USB flash
drive.
6 Determine the device name of your USB flash drive:
a If the USB flash drive was automatically mounted (and subsequently
unmounted), use the device name assigned by Linux in the steps
below.
b If the USB flash drive was
not previously mounted, generate a dmesg
log to show the newly connected devices.
Enter:
dmesg
Examine the log messages to determine the device name for the USB flash
drive.
7 Write the image from the CD-ROM to the USB flash drive:
dd bs=1M if= of=
where is the name of the SLETC image on the
CD-ROM (for example:
/media/Novell_SLETC_for_Dell/Novell-SLETC-10-SP2-
1-for-Dell.raw ), and is the device name
of the USB flash drive.
8 When the write operation is complete, remove the USB flash drive from
the Linux system and use it to re-image the FX160 computer (see
"Re-Imaging SLETC on an FX160 Computer With a USB Flash Drive" on
page 10).
Create a Linux Bootable USB Flash Drive With Windows
The update CD provided includes these three files:
• Documentation (*.pdf)
• SLETC update file (*.raw). The name of this file reflects the revision
level of SLETC.
• Windows USB flash drive image installer (USBDiskImageTool.exe)