Speakers, audio connectors, and consumer infrared, Removing speakers, Removing the audio connector board – Dell XPS M1730 User Manual
Page 40
Back to Contents Page
Speakers, Audio Connectors, and Consumer Infrared
Dell™ XPS™ M1730 Service Manual
Removing the Audio Connector Board
Removing the Consumer Infrared Board
Removing Speakers
1.
Follow the instructions in
Before You Begin
.
2.
Remove any installed ExpressCards from the ExpressCard slot.
3.
Remove any installed memory modules or Mini Cards (see
Memory
and
Communication Cards
).
4.
Remove the hard drive (see
Hard Drive
).
5.
Remove the palm rest (see
Palm Rest
).
6.
7.
Remove the two speaker screws (one on each speaker) from the computer base.
8.
Disconnect the speaker connector from the system board.
9.
Remove the two speakers by lifting them up.
Removing the Audio Connector Board
1.
Follow the instructions in
Before You Begin
.
2.
Remove the palm rest (see
Palm Rest
).
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1
screws (2)
2
speakers (2)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.