Garmin GPSMAP 3005C - Manual (Page 105)

GPSMAP 3005C Owner’s Manual
A
PPendIX
> I
nstAllIng And
r
eMovIng
d
AtA
c
Ard
Installing and Removing the Data Card
The GPSMAP 3005C uses optional Garmin BlueChart and MapSource data
cards. By updating your GPSMAP 3005C software to version 3.0 or later, you can
use optional preprogrammed BlueChart g2 data cards.
Insert the data card in the card slot located on the front left of the unit. Data cards
can be installed or removed at any time, whether the unit is on or off.
To install the data card:
1. Open the data card door by sliding the door in the direction of the arrow,
and lift the door open from left to right.
2. Insert the card into the slot, with the label facing the right screen and the
handle facing toward you.
3. Push the card into the unit. It in not necessary to force the card and
about 1/2" is still exposed when it is properly inserted. If the unit is on, a
confirmation tone sounds, and a message appears on-screen noting the
card details when the card is properly installed and accepted.
4. Close the cover until it locks.
If you insert a data card and get a card format not recognized message, remove
the card and reinsert it. If the card is still not recognized, contact Garmin Product
Support or your Garmin dealer for assistance.
NOTE: Data cards are not waterproof, should not be exposed to moisture or
excessive static charges, and should be stored in the case supplied with the
card. Data cards are a Garmin proprietary device and are not interchangeable
with the SD cards used for Garmin g2 Vision mapping data.
The first time you insert a data card, the unit takes a few seconds to read the
card. After the data card is read, a summary page appears. Press ENTER to
acknowledge.
PAGE
QUIT
ENTER
MARK
ADJ
MENU
DATA
FCTN
FIND
CNFG
NAV
MOB
Slde the data card door n
the drecton of the arrow (to
the left) and pull to open t.
Data Card slot
To remove a data card:
1. Open the data card door by sliding the door in the direction of the arrow,
and lift the door open from left to right.
2. Grasp the card handle and pull out firmly.
3. If the unit is on, a confirmation tone sounds when the data card is
removed.
a
ppend
IX