Garmin GNC 300XL TSO - Manual (Page 126)

116
APPENDIX
C SIMULATOR
Entering an initial position reference.
Database confirmation page
To enter an initial position reference by waypoint identifier:
1. Rotate O to highlight the waypoint identifier field.
2. Use
K
and
O
to spell out the identifier of the desired airport, navaid or user waypoint.
3. Press
E
to confirm the identifier. The waypoint confirmation page will appear, display-
ing the waypoint’s position.
4. Press
E
to confirm the ‘ok?’ prompt.
The position page will now appear, and you may now use most of the GNC 300XL
navigation features for practice and planning. You’ll also receive a ‘Do not use for nav’
message to remind you that the simulator mode should never be used for actual navi-
gation. During simulator operation, you will be able to enter a ground speed from the
CDI page, and define a course to a destination from the direct-to confirmation page.
Altitude may only be entered by using the VNAV function available from the NAV
menu 1 page (see page 26).
To enter a ground speed from the CDI page:
1. Press
N
and rotate
O
to display the CDI page.
2. Press C twice to activate the cursor in the GPS window.
3. Rotate
O
to highlight the ground speed field.
4. Use
K
and
O
to enter the desired speed. Press
E
to accept, and
C
to finish.
To exit the simulator mode, the GNC 300XL must be turned off by rotating the B
knob counterclockwise until the unit shuts down. All waypoints and routes created in
simulator mode will be retained in the GNC 300XL’s internal memory.
300xl manual 1/25/99 2:36 PM Page 116