AcuRite 00825 Weather Station - Manual (Page 4)

SECTION 3 • PLACEMENT
Now that setup is complete, you must choose a location to place the 3
wireless sensors and the main unit. The wireless sensors MUST be
placed LESS THAN 100 feet away from the main unit.
This wireless weather station uses radio frequency for communication,
which is susceptible to interference from other electronic devices and
large metallic items or thick walls. Always place both units at least 3 feet
away from appliances ( TV, microwave, radios, etc. ) or objects ( large
metal surfaces, thick stone walls, etc. ) that may interfere with the
wireless communication.
- 7 - - 6 -
(NORTH)
WIND
MAIN
UNIT
TEMP.
& HUMIDITY
Place the main unit in a dry area free of dirt and dust. To help ensure
an accurate indoor temperature measurement, be sure to place the
main unit out of direct sunlight, and away from any heat sources or
vents in your home.
There are 2 placement options for the main unit. You may hang the
main unit on a wall using the integrated hang hole on the back.
Alternatively, you may place the main unit on a table top or other flat
surface utilizing the removable main unit display stand.
Placement of Main Unit
The wireless sensors MUST BE PLACED OUTDOORS to observe
outdoor weather conditions and relay them to the main unit display.
The wireless sensors must be placed less than 100 feet from the
main unit.
Placement of Sensors
N
E W NW
SW
NE
SE S
AM PM TIMEZONE DST
FUTURE FORECAST OUTDOOR WIND GUST
WIND SPEED
INDOOR
WIND CHILL
PST MST CST EST OFF ON
InHg HISTORY HR. PRESSURE hPa
mph kph knots
mph kph knots MIN MAX
MIN MAX
MIN MAX
PLACEMENT
1. Attach to a solid vertical OR
horizontal surface out of direct
sunlight for maximum
performance. Attach the
mounting bracket utilizing the
included screws and wall
anchors (if applicable).
Depending on the mounting
surface, other steps may need
to be taken to ensure the
sensor is mounted securely.
2. Attach the temperature &
humidity sensor to the
mounting bracket by simply
sliding into the bracket.
Wireless Temperature
& Humidity Sensor
PLACEMENT
1. Attach the wind sensor to the
mounting bracket by simply
sliding into the bracket.
2. The sensor must be mounted
with the bracket pointing NORTH
as indicated on the bracket and
on the top surface of the wind sensor itself. The wireless wind sensor
should be mounted high above all potential wind obstructions for
maximum performance, keeping in mind it must remain within the 100
ft. wireless range of the main display unit.
Attach to a solid surface utilizing screws and wall anchors (if applicable).
Depending on the mounting surface, other steps may need to take place
to ensure the sensor is mounted successfully.
Wireless Wind Sensor
NORTH NORTH
VERTICAL
SURFACE
HORIZONTAL
SURFACE