ACR&Artex Float-Free 406 Memory Capsule - Manual (Page 11)

7 Y1-03-0202 Rev. E
Force RLB-35MC Pointer Reset.
This option will reset the current write location to the beginning of
Main Memory.
Note: To read back the data just written, choose the ‘Download from
beginning of memory to current write location’ option from the ‘RLB-
35MC Data Receive Setup’ window, then click the ‘Receive Data’
button. See the Demo Data Download Mode Section below.
Enter Data Burst Mode
This mode writes a file to the Main Memory area starting at the current
write location. Choose the ‘Enter Data Burst Mode’ from the ‘Data
Upload Mode’ pull-down menu.
Writing a File
After the upload mode is selected, click the ‘Send WR Command’. The
‘Send Test File Data’ can be selected repeatedly to write data to the
Main Memory. Each time this option is selected the user will be
prompted for the name of the file to write to memory. The current
write pointer is advanced each time data is written.
Disconnecting Port 7000
Clicking the ‘Disconnect Port’ button will disconnect the port.
5.6. Data Download Mode
Four options are available on the demonstration software for reading
data from the Main Memory area. Select the download mode before
reading data from memory.
Select menu item “Data Download Parameters” and note the four
options. When selected a dot appears in the circle to the left of the
option.
Download ALL capsule data
This option will read all of the Main Memory area starting at an address
that is the specified number megabytes ahead of the current write
location. Enter the desired number of megabytes for the offset.
Download Megabytes
This option will read a specified number of megabytes of Main Memory.
Enter the number of megabytes to read. The current write address
will be the last address to be read.