Acclaim Lighting AL Driver 8-RGBW 24V - Manual (Page 4)

2.Main Features
3.Power & DMX Setup
3.1. Power Supply:
-The AL-Driver-8RGBW as a hybrid&universal LED lighting driver unit is used to
drive LED lightings, i.e. X-Chip series, AL-Eye-STD etc from
.
-12 digit dipswitch for functional setup.
-USITT DMX512(1990) multiplexed digital control, via 3 pin XLR connector.
-DMX Control Mode and Stand Alone Mode available .
-0~100% fade time.
-0.1S~30S chasing speed.
-Built-in programs1~7 and a sequence of 7 programs(Auto).
-Output modes available, including
110-120VAC(3.2A)/220-240VAC(1.6A) power input standards optional via voltage selector.
-With built-in 4 different PSU for user selection, available in 12VDC, 15VDC, 18VDC
and 24VDC.
-Power failure memory.
Acclaim Lighting
-Pure White (Intensity)
-Color (RGB) with white (saturation)
-RGB color only
-
-2-
Before plugging your unit in, be sure the source voltage in your area matches the required
voltage for your AL-Driver-8RGBW power supply. The AL-Driver-8RGBW is available in a
120v and 230v version. Due to variations in line voltage from venue to venue, be sure to
plug your power supply into a wall outlet with matching power before attempting to operate.
*Note: Figure 1
3.2. Data Cable (DMX Cable) Requirements:
If you are constructing your own data cables, be sure to use
standard two conductor shielded cable (This cable may be
purchased at almost all professional sound and lighting stores).
Your cables should be made with a 3-pin male and female XLR
connector on either end of the cable. Also remember that DMX
lines must be daisy chained and can't be split.
Figure 2 DMX 512 OUT
3-PIN XLR
DMX 512 IN
3-PIN XLR
COMMON
DMX+
DMX-
Be sure to follow figures two and three when making your own cables. Do not use the
ground lug on the XLR connector. Do not connect the cable's shield conductor to the ground
lug or allow the shield conductor to come in contact with the XLR's outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
The AL-Driver-8RGBW can be controlled via DMX-512 protocol and your DMX controller
requires a standard 3-pin XLR connector for data input and data output(Figure1). Connect
the AL-Driver-8RGBW and your fixtures together using standard 3 pin DMX cables. The AL-
Driver-8RGBW uses DMX-512 protocol to operate your fixtures.
234 88 44 100
235 76 38 100
236 64 32 100
237 50 25 100
238 44 19 100
239 38 13 100
240 32 7 100
241 25 12 100
242 19 18 100
243 13 24 100
244 7 30 100
245 12 36 100
246 18 42 100
247 24 48 100
248 31 62 100
249 37 74 100
250 43 86 100
251 49 98 100
Blue @ Full
Proportional Red and Green
252 62 100 100
253 74 100 100
254 86 100 100
Blue and Green @ Full
Proportional Red
255 100 100 100 Red,Green,Blue @ FULL
(White)
6.Appendix
-11-