JVC GR-D21 - Manual (Page 19)

EN
19 FOR RECORDING
Manual Focus
To obtain correct focus.
1
If you are using the viewfinder, you should already
have made the necessary viewfinder adjustments
(
੬
pg. 8).
2
Set the Power Switch y to “ ” while pressing
down the Lock Button t located on the switch, then
press FOCUS & (
੬
pgs. 40 and 41). The manual
focus indicator appears.
3
To focus on a farther subject, rotate the MENU/
VOLUME wheel $ towards “+”. “ ” q appears and
blinks.
To focus on a nearer subject, rotate the MENU/
VOLUME wheel
$ towards “–”. “ ” q appears and
blinks.
4
Press the MENU/VOLUME wheel $ in. Focus
adjustment is complete.
To reset to Auto Focus, press FOCUS & twice or set
the Power Switch y to “ ”.
If FOCUS & is pressed once, the camcorder will enter
the focus adjustment mode again.
NOTES:
● Be sure to focus the lens in the maximum telephoto
position when you use the Manual Focus mode. If you
focus in on a subject in the wide-angle position, sharply
focused images cannot be obtained when zoomed up
because the depth-of-field is reduced at longer focal
lengths.
● When the focus level cannot be adjusted any further or
closer, “ ” or “ ” will blink.
Exposure Control
Manual exposure adjustment is recommended in the
following situations:
• When shooting using reverse lighting or when the
background is too bright.
• When shooting on a reflective natural background
such as at the beach or when skiing.
• When the background is overly dark or the subject
light.
1
Set the Power Switch y to “ ” while pressing
down the Lock Button t located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
2
Press the MENU/VOLUME wheel $ in. The Menu
Screen appears.
3
Rotate the MENU/VOLUME wheel $ to select
“ (EXPOSURE)”, then press it.
4
Rotate the MENU/VOLUME wheel $ to select
“MANUAL”, then press it. The Menu Screen disappears.
The exposure control indicator appears.
5
Rotate the MENU/VOLUME wheel $ towards “+” to
brighten the image, or towards “–” to darken the image.
(maximum ±6)
6
Press the MENU/VOLUME wheel $ in. Exposure
adjustment is complete.
To Return To Automatic Exposure Control . . .
..... select “AUTO” in step 4. Or, set the Power Switch
y to “ ”.
To Brighten The Subject Quickly . . .
..... press BACKLIGHT 0 . 4 is displayed and the
subject is brightened. If pressed again, 4
disappears and the brightness returns to the
previous level.
• +3 exposure has the same effect as the BACKLIGHT
Button 0 .
• Using BACKLIGHT 0 may cause the light around the
subject to become too bright and the subject to
become white.
• Backlight compensations is also available when the
Power Switch y is set to “ ”.
NOTE:
You cannot use the manual exposure control at the same
time with backlight, spotlight (
੬
pg. 16) compensation and
“SNOW” (
੬
pg. 16).
While focusing on
a nearer subject While focusing on
a further subject
Focus detection zone
GR-D31/21EK 16-27 02.12.19, 9:15 PM 19