HONDA 2010 Civic Hybrid - Manual (Page 300)

Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks. Put the fasteners into the holes on
the side of the trunk lining.
Reinstall the screws.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Turn on the lights to make sure
the new bulb is working. Open the trunk.
Use the Phillips-head screwdriver to
remove the screws in the center of
each fastener on the back of the boot
lid. Remove the fasteners first, then
pull the lining back carefully.
1.
4.
5.
6.
7.
8.
3.
CONTINUED
Replacing Rear Bulbs
(in Trunk Lid)
Lights
Ma
int
e
na
nce
297
BULBS
SOCKETS
SOCKETS
BULB
BULB
FASTENER
09/07/15 11:10:07 31SNC640_302
2010 Civic Hybrid