FIAT 500 User Manual

Page 24

TRIP COMPUTER

General information

The Trip computer is used to display information on
car operation when the key is turned to MAR.
This function is composed of separate trips, called
“Trip A” and “Trip B” which can monitor the entire
mission (journey) in a reciprocally independent
manner.
Both functions can be reset (reset means start of a
new journey).
“Trip A” is used to display the figures relating to:
❒ Range
❒ Distance travelled
❒ Average consumption
❒ Current consumption
❒ Average speed
❒ Trip time (driving time).
“Trip B” may be used to display the figures relating
to:
❒ Distance travelled B
❒ Average consumption B
❒ Average speed B
❒ Trip time B (driving time).

Note The “Trip B” function may be disabled (see
“Activating Trip B”). “Range” and “Instant
consumption" parameters cannot be reset.

Values displayed

Range

This value shows the distance that the car can still
cover before needing fuel, assuming that driving style
is unvaried. “- - - -” will appear on the display in
the following cases:
❒ range value lower than 50 km (or 30 mi)
❒ car parked with engine running for a long period.

IMPORTANT The range can be affected by several
factors: driving style (see “Driving style” paragraph in
the “Starting and driving” chapter), type of route
(motorway, towns and cities, mountain roads, etc.),
conditions of use (load, tyre pressures, etc.). Trip
planning must therefore take the above into account.

Distance travelled

This value shows the distance covered from the start
of the new journey.

Average consumption

This value shows the approximate average fuel
consumption from the start of the new journey.

Current consumption

This value shows the fuel consumption. The value is
constantly updated. The display will show “- - - -”
if the car is parked with the engine running.

GETTING TO

KNOW YOUR CAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX