FIAT 500 User Manual

Page 182

CHANGING THE REAR WINDOW WIPER
BLADE

Proceed as follows:
❒ raise the cover A fig. 141 and remove the arm

from the car, undoing the nut B fig. 141 that
fastens it to the pivot pin;

❒ fit the new arm, positioning it correctly, and fully

tighten the nut;

❒ lower the cover.

WINDSCREEN JETS (WASHERS)

If the jet of fluid is inadequate, firstly check that
there is fluid in the reservoir (see "Checking fluid
levels" in this chapter).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
The windscreen jets are directed by adjusting the
angle of the nozzles.
The jets should be directed at about 1/3 of the
height from the top edge of the windscreen fig. 142.

IMPORTANT In versions with a sun roof, make
sure that the sun roof is closed before operating the
front jets.

fig. 141

F0S0109

fig. 142

F0S0110

179

GETTINGTO KNOW

YOURCAR

SAFETY

STARTING AND

DRIVING

WARNING LIGHTS

AND MESSAGES

IN AN EMERGENCY

SERVICING AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX