STIEBEL ELTRON DHC-E 8-10-12 01.12.2011 - 13.02.2011 - Manual (Page 4)

HTV`.HC
&CV<
Ф ’+й qqqĪZ`.
<é<`VHCĪHB
3. General
The tankless water heater differs from conventional storage type
water heaters in several ways. It does not store hot water. Instead,
water is heated instantaneously as it flows through the appliance.
Due to the absence of stand-by losses, the appliance offers greater
energy efficiency than storage type water heaters.
2
6
_0
2_0
2
_1
0
8
6
The input of heat into the water is electronically controlled. The
appliance will deliver any water temperature between 86 °F (30
°C) and 140 °F (60 °C). Please set the desired temperature using
the knob on the front cover. In case the “Power” light is flashing
while the appliance operates, the water flow rate exceeds the
heating capacity of the appliance. Reduce the hot water flow rate
in order to let the appliance achieve the set point temperature.
The maximum temperature is electronically limited to 140 °F (60
°C). In case you have questions regarding the way you plan to use
the appliance, please call our technical service line, see last side.
4. Troubleshooting
ZźăĤŒĒă TĒńńêù¼ |şń¼ f ZĒùşŒêĒĉ
No hot water not enough flow rate to
activate appliance
clean faucet aerator or shower
head
Water not hot enough water flow too high reduce water flow rate until
light on front cover stops
blinking
If you cannot remedy the fault, notify the contractor who installed
the appliance. To facilitate and speed up your enquiry, please pro-
vide the serial number from the type plate (000000-0000-000000).