RIDGID micro CL-100 - Manual (Page 5)

micro CL-100 Self-Leveling Cross Line Laser
3
Safety Symbols
In this operator’s manual and on the product, safety symbols and signal words are used to
communicate important safety information. This section is provided to improve understand-
ing of these signal words and symbols.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER
WARNING
CAUTION
NOTICE
DANGER indicates a hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in mi-
nor or moderate injury.
NOTICE indicates information that relates to the protection of property.
This symbol means read the operator’s manual carefully before using the equipment.
The operator’s manual contains important information on the safe and proper operation
of the equipment.
This symbol means this device contains a Class 2 La-
ser.
This symbol means do not stare into the laser beam.
This symbol warns of the presence and hazard of a
laser beam.
General Safety
Information
WARNING
Read all safety warnings and instructions.
Failure to follow the warnings and instruc‑
tions may result in electric shock, fire and/
or serious injury.
SAVE THESE INSTRUCTIONS!
Work Area Safety
• Keep your work area clean and well
lit. Cluttered or dark areas invite acci-
dents.
• Do not operate equipment in explosive
atmospheres, such as in the presence
of flammable liquids, gases or dust.
Equipment can create sparks which may
ignite the dust or fumes.
• Keep children and by-standers away
while operating equipment. Distrac-
tions can cause you to lose control.
Electrical Safety
• Avoid body contact with earthed or
grounded surfaces such as pipes, radi-
ators, ranges and refrigerators. There
is an increased risk of electrical shock if
your body is earthed or grounded.
• Do not expose equipment to rain or
wet conditions. Water entering equip-
ment will increase the risk of electrical
shock.
Personal Safety
• Stay alert, watch what you are do-
ing and use common sense when
operating equipment. Do not use a
tool while you are tired or under the
influence of drugs, alcohol or medi-
cation. A moment of inattention while
operating equipment may result in se-
rious personal injury.
• Do not overreach. Keep proper foot-
ing and balance at all times. This en-
ables better control of the the equip-
ment in unexpected situations.
DO NOT STARE INTO BEAM
LASER RADIATION
MAXIMUM OUTPUT < 1mW
WAVELENGTH 630-670nm
CLASS 2 LASER PRODUCT
EN 60825-1:1994/A11:1996/A2:2001/A1:2002
CAUTION