English – Vitek VT-1510 SR User Manual

Page 9

ENGLISH

• Unplug power cord from wall outlet and wait until coffee machine is cooled down com-

pletely.

• Install percolator-filer (b) to its place, and tighten fastening screw (a) by screwdriver

rotating it anticlockwise.

CLEANING
Wipe the body of the coffee maker with a damp soft cloth. Do not use abrasives and metal
sponges.
Do not immerse the body of the coffee maker into water or other liquids
Wash the removable parts of the coffee maker in warm water with a soft detergent, rinse
and dry.

Water tray (1)
• Remove the grid (2) from the tray (1), remove the tray (1) from the base and pour water

from the tray (1) set the tray (1) on its place, set the grid (2) on the tray (1). If necessary
you can wash the tray (1) and the grid (2) in warm water with a soft detergent, rinse and
dry.

PROBLEMS, THEIR CAUSES AND SOLUTIONS:

Problem

Cause

Solution

“Espresso”

Is not hot enough

Cups, and the filter holder (3) were

cold.

Heat the accessories preliminary

(Cups and the filter holder). See

the “Making espresso” chapter

The filter holder (3) is set improp-

erly and not until bumping.

See the “Making espresso” chap-

ter

Coffee leakage

from the filter holder

(3)

Coffee grouts on the sides of the

filter.

Clean the filter sides.

The gasket (3) is damaged.

Apply to the authorized service

center.

No water in the water tank (9).

Fill the water tank (9) with water.

When water supply

is switched on, the

pump produces

noise

The water tank (9) is set improp-

erly.

Press on the tank (9) above to set

it on its place.

Ground coffee is too dry, and the

pump can not produce necessary

pressure

Use freshly ground coffee.