Edimax Technology WD-1000TR - Manual (Page 5)

4
CAUTION: Using the RF module in
the US
z
Any changes or modifications not
expressly approved by the grantee of this
device could void the user's authority to
operate the equipment.
z This equipment must be installed and
operated in accordance with provided
instructions and the antenna(s) used for
this transmitter must be installed to
provide a separation distance of at least
20 cm from all persons and must not be
co‐located or operating in conjunction
with any other antenna or transmitter.
End‐users and installers must be provide
with antenna installation instructions and
transmitter operating conditions for
satisfying RF exposure compliance.
z Outdoor operations in the 5150 ~
5250MHz, 5600~5650MHz band are
prohibited.
z This device has no Ad‐hoc capability for
5250~5350MHz and 5470~5725MHz.
z Outdoor operations in the
5470~5725MHz band are prohibited. This
device could not be used in the
5600~5650MHz.
z The Device not operation in
5600~5650MHz.
z Industry Canada regulatory information
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
z The user is cautioned that this device
should be used only as specified within
this manual to meet RF exposure
requirements. Use of this device in a
manner inconsistent with this manual
could lead to excessive RF exposure
conditions.
z The following statement must be included
with all versions of this document
supplied to an OEM or integrator, but
should not be distributed to the end user.
¾ This device is intended for OEM
integrators only.
¾ Please See the full Grant of
Equipment document for other
restrictions.
¾ This device must be operated and
used with a locally approved access
point.
z The following regulatory and Safety
notices must be published in
documentation supplied to the end user
of the product or system incorporating an
adapter in compliance with local
regulations, Host system must be labeled
with “Contains FCC ID: XXX‐XXXXX”, FCC
ID displayed on label.
System Warning
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
z Reorient or relocate the receiving
antenna.
z Increase the separation between the
equipment and receiver.
z Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
z Consult the dealer or an experienced
radio/TV technician for help.