Edimax Technology IC-3010 - Manual (Page 16)

16
1.6 Camera Installation
Please follow the following instructions to set your IP camera up.
Unpack the product package and check if anything
‟s missing.
Connect the antenna to the antenna base, which is located at the top of this IP camera.
Plug the power adapter to wall socket, and connect the power connector to the power jack
located at the bottom of the IP camera.
Connect the Ethernet cable to your local area network, and connect the other end to the
LAN jack of this IP camera.
NOTE: You can skip this step if you plan to use wireless LAN only.
Connect your tripod / camera holder, and point the camera to the place you wish to monitor.
6. Connect the external speaker
‟s audio cable to „Speaker‟ jack located at the bottom of this
IP camera.
If you don ‟t need audio support, you can skip this step.