Update software tftp Page 59: Telnet commands, Close, Help, Send
Page 59: Telnet commands, Close, Help, Send
TELNET Commands
A-21
update software tftp
server
path
VERIFY
verify filter
Verifies the syntax of a filter file, which has been previously added to the table. If
you update a filter file and TFTP it to the FLASH file system, and the file already
exists in the filter table, then you use this command to verify the files syntax. You
can use list filters to see which files are currently in the filter file table, and what
the status of each is.
TELNET
Commands
The following commands are available to TELNET users. They are accessed by
pressing control - ].
close
Closes the active TELNET connection.
help
Lists the available commands
send
Transmits a TELNET control character. Be sure the parameters are uppercase. The
choices are:
set_escape
Allows changing the TELNET escape character from ^] to something else. Control
characters are specified using the carat character followed by another character.
For example, to set the TELNET escape character to control - X, type set_escape
^X.
status
Displays the IP address of the remote host and the value of the TELNET escape
character.
CLI Exit
Commands
These commands are available to TELNET users so they can disconnect from the
CLI.
Bye, Exit, Leave, Quit
Leave the CLI, but keep this connection open. This command returns you to the
TELNET commands.
Parameters
Description
AYT
Are you there
IP
Interrupt process
BRK
Break
AO
abort output
EC
erase character
EL
erase line
GA
go ahead
NOP
no - operation
EOR
end of record
SYNC
synch