3Com ADSL Modem Ethernet - Manual (Page 58)

A-20 A PPENDIX A: CLI C OMMAND D ESCRIPTION
show snmp settings Displays SNMP settings, which you can modify using enable or disable snmp
authentication traps commands.
■
Authentication Traps - ENABLED (default) or DISABLED
show system Displays system information.
■
System Descriptor - for example:
3Com HomeConnect™ Remote 810 V1.0.0, Built on Oct 31 1996 at 11:33:05.
■
Object ID - identifies this system to SNMP managers
■
System UpTime - time the system has been running since last boot
■
System Contact - modify using set system
■
System Name - modify using set system
■
System Location - modify using set system
■
System Services - for example, Internet End To End Applications
■
System Version - loaded version of the system software
show user
settings
Displays the parameters defined for the specified TELNET user. You can use list
users to see which users are defined.
TELNET TELNET commands are available to users who dial in, and whose type is network
(type parameter in add user), whose host_type is prompt (host_type parameter in
set login user), and whose login_service is TELNET (login_service parameter in set
login user).
telnet Establishes a TELNET client session with the specified IP address.
telnet
TCP_port
Establishes a TELNET client session with the specified IP address using the specified
TCP port number. It works just like the TELNET command, except you also specify
the TCP port number to be used. The default TCP port number is 23.
UPDATE The Update Software FTP and Update Software TFTP commands allow you to
utilize the 3Com HomeConnect ADSL Modem Ethernet FTP or TFTP clients to
obtain and install the new operational software. You can access these commands
directly from the serial console CLI session or through TELNET.
To update the software using the FTP command, use the CLI command:
update software ftp server
path
username
password
To update the software using the TFTP command, use the CLI command: