Set interface Page 51
Page 51
CLI Commands
A-13
■
UNUSUAL - an abnormal event, which the system should recover from
■
COMMON - a regularly occurring event that is not frequent
■
VERBOSE - a regular periodic event, e.g. a routing update message
■
DEBUG - for debugging purposes only
set interface
filter_access [ON | OFF]
input_filter
output_filter
Sets filter parameters for the specified protocol on the specified interface. You can
see the available filter files using list filters, view the contents of a filter file using
show filter, and add filter files to FLASH memory using TFTP.
set port
pcr [number]
vci [number]
vpi [number]
description [filter_name]
input_filter [filter_name]
output_filter [filter_name]
Specifies bridge port parameters.
Parameters
Description
Designation of interface you are setting parameters for. Limit of 32
characters.
filter_access
ON causes filters specified for an interface with a set interface com mand,
to override filters specified with a set user command, when the filters are
of the same type.
input_filter
Name of filter file you wish to be applied to the input stream coming in on
the specified interface. Limit: 20 characters.
output_filter
Name of the filter file you wish to be applied to the output stream leaving
the specified interface. Limit: 20 characters.
Parameters
Description
Port number (2..9)
input_filter
Designation of the filter file in FLASH memory to be applied to the
input data stream.
output_filter
Name of the filter file in FLASH memory to be applied to the out put
data stream.
Pcr
Peak Cell Rate (both UBR and VBR).
Vci
Virtual Channel Identifier.
Vpi
Virtual Path Identifier.