3Com 10/100BASE-T4 - Manual (Page 27)

Using NetWare ODI 3-7
5 Read the screen and press [Enter].
6 When the main menu screen shown in Figure 3-2 appears,
select NetWare DOS ODI Client, and press [Enter].
Figure 3-1 AutoLink Information Screen
Figure 3-2 Main Menu
ESC=Cancel
This option will install a complete DOS ODI client.
[ENTER]=Continue
[ESC]=Exit Program
3Com's auto installation software (AutoLink) automatically configures your
adapter and workstation for use as a NetWare client. To use AutoLink:
* Have only one 3Com Etherlink III PCI adapter installed
* Use NetWare v2.X, v3.1X, or v4.X as your network operating system
* Have DOS on the client being installed
AutoLink edits your AUTOEXEC.BAT and CONFIG.SYS files and saves the old
versions. Select General Information/Release Notes in the main menu for
information on AutoLink server support. To manually set up your adapter
or for information/drivers for other NOSs, use the options under Standard
Installation and Configuration in the main menu.
EtherDisk-3C59X Fast EtherLink/EtherLink III Bus Master Adapter Family v.4.2
(C) Copyright 1995, 3Com Corporation. All Rights Reserved
ESC=Cancel F1=Help
M A I N M E N U
This option will install a complete DOS ODI client.
[ENTER]=Execute Function
[
-¯ ]=Scroll
[F1]=Help [ESC]=
Auto Installation with Configuration (AutoLink)
NetWare DOS ODI Client
EtherDisk-3C59X Fast EtherLink/EtherLink III Bus Master Adapter Family v.4.2
(C) Copyright 1995, 3Com Corporation. All Rights Reserved
Standard Installation and Configuration
Network Drivers ...
Configuration/Diagnostic/Troubleshooting ...
General Information/Release Notes