3Com 10/100BASE-T4 - Manual (Page 25)

Using NetWare ODI 3-5
6 Double-click the adapter name to display a description of
the adapter and its current status.
The next dialog box confirms that the adapter is working
properly.
7 Click the Cancel button to leave each dialog box and
return to the Control Panel.
Using NetWare ODI
This section describes how to load NetWare drivers in the
following networking situations:
■
One or more adapters in a client
■
One or more adapters in a server
One Adapter in a Client
3Com’s AutoLink installation program automatically installs all
necessary NetWare DOS ODI client software, including drivers
and modifies the CONFIG.SYS and AUTOEXEC.BAT files. It
automatically logs on to the server and updates the client
software if your system administrator has already configured
a 3Install account on the server. Instructions for configuring
a 3Install account are contained in the README.TXT file
located in the \QINSTALL\SERVER directory on the
3C59X EtherDisk diskette.
AutoLink Requirements
To use the AutoLink program to install the NetWare DOS ODI
driver, your computer must meet the following requirements:
■
Use the Novell NetWare 2.x, 3.1x, or 4.x network operating
system
■
Have only one 3C595-T4 adapter installed
■
Have at least 1 MB of hard disk space available
■
Be intended for use as a NetWare DOS ODI client
If this does not describe your network environment, refer to
the appropriate section later in this chapter.