3M MP8749 - Manual (Page 17)

16
STANDBY/ON
LASER
BLANK
RGB VIDEO
AUTO
MENU
ENTER
KEYSTONE
RESET
FREEZE ASPECT ESC
MAGNIFY
POSITION
OFF ON
VOLUME
MUTE
1
Press the STANDBY/ON button (control
panel or remote control)
The message "Power off?" will appear on the screen for approximately 5 seconds.
3
Check that the POWER indicator stops
blinking and lights to solid orange.
Switch the power switch to [O] (OFF).
4
Confirm that the POWER indicator has gone
off and then close the slide lens door.
When the projector has completed powering down, the
POWER indicator will go off.
STANDBY/ON
TURNING OFF THE POWER
Control panel
2
Press the STANDBY/ON button again
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?"
message is visible. The projector lamp goes off and starts cooling
down. The POWER indicator blinks orange while the lamp cools
down. (Pressing the STANDBY/ON button while the POWER
indicator is blinking orange has no effect.)
The system goes into the STANDBY mode after cooling
down and the POWER indicator stops blinking
orange and then lights to solid orange.
STANDBY/ON
• Except in
emergencies, follow
the above-
mentioned
procedure for
turning power off.
NOTE
POWER-indikator
på/av-bryter