Xerox 8500/8550 User Manual
Page 135
Phaser® 8500/8550 Color Printer
A-2
The power cord is attached to the printer as a plug-in device at the back of the printer. If it is
necessary to disconnect all electrical power from the printer, disconnect the power cord from
the electrical outlet.
Warning:
Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are specifically instructed to do so. Power should be OFF
when performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are no parts
that you can maintain or service behind these covers.
Note:
Leave the printer on for optimum performance; it does not pose a safety hazard.
The following are hazards to your safety:
■
The power cord is damaged or frayed.
■
Liquid is spilled into the printer.
■
The printer is exposed to water.
If any of these conditions occur, do the following:
1.
Turn off the printer immediately.
2.
Disconnect the power cord from the electrical outlet.
3.
Call an authorized service representative.
Maintenance Safety
■
Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
■
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
■
Do not burn any consumables or routine maintenance items. For information on Xerox
supplies recycling programs, go to
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.