Yamaha AV-S7 - Manual (Page 7)

E-3
English
WARNING
To reduce the risk of fire or electric shock, do not
expose this system to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
MAIN POWER switch
The U.K. and Europe models are equipped with a
MAIN POWER switch on the rear bottom panel of
the power amplifier/subwoofer (SW-AVS7).
Setting this to ON switches the AV-S7 system to
STANDBY mode. To power on the system, press
the STANDBY/ON button on the center speaker or
the POWER button on the remote control
transmitter.
For U.K. customers
If the socket outlets in the home are not suitable for the
plug supplied with this appliance, it should be cut off
and an appropriate 3 pin plug fitted. For details, refer to
the instructions described below.
Note: The plug severed from the mains lead must be
destroyed, as a plug with bared flexible cord is
hazardous if engaged in a live socket outlet.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT
THE WIRES IN THE MAINS LEAD ARE COLOURED
IN ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked with the
letter N or coloured BLACK. The wire which is
coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
Make sure that neither core is connected to the
earth terminal of the three pin plug.
PRECAUTIONS
This system is still connected to the AC power
source as long as it is connected to the wall outlet,
even if the system itself is turned off.
In this state, this system is designed to consume a
very small quantity of power. Pressing the
STANDBY/ON button (or POWER button) lights up
the STANDBY indicator and puts the system into
standby. This is called STANDBY mode.
VOLTAGE SELECTOR (FOR GENERAL AND
CHINA MODELS ONLY)
The voltage selector on the bottom of the power
amplifier/subwoofer (SW-AVS7) must be set for
your local main voltage BEFORE plugging into
the AC main supply.
Voltages are 110/120/220/240V AC, 50/60 Hz.
VOLTAGE
SELECTOR
CAUTION (FOR CANADA MODEL)
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT AND FULLY
INSERT.
FOR CANADIAN CUSTOMER
THIS CLASS B DIGITAL APPARATUS MEETS ALL
REQUIREMENTS OF THE CANADIAN
INTERFERENCE-CAUSING EQUIPMENT
REGULATIONS.
FOR U.K. AND EUROPE MODELS ONLY
AV-S7(E)(E/F)1-16 9/11/0 9:36 AM Page E-3