Yamaha CC-50 - Manual (Page 42)

E-40
To begin CD playback from a desired track by the
timer play.
1. Play back the track which you want to play back from the
beginning of the timer play.
2. Press the RESUME button on the CD player so that “ ”
appears on the display.
3. Make the timer play setting.
4. Turn the power off while the track is being played back.
when the time comes, the timer play begins from the
beginning of the track.
* If you will not play back a CD from a designated track by
the timer play, press the RESUME button so that “
”
disappears from the display.
Timer recording
(To record a tuner program)
1
Load a blank tape into the DECK B cassette
compartment.
2
Tune to the station of which program you want to record.
3
Follow step 2 of the “Timer play” on pages 38 and 39.
* In step 2- ➁ , select “TUNER” by pressing the INPUT
selector or button, and then press the TIMER
REC button so that “REC” and the station frequency
flashes alternately.
4
If desired, change the setting of the reverse mode switch
and the Dolby NR switch.
5
If you will not use this unit untill the timer recording
begins, turn the power off by pressing the POWER switch
or the TIMER button.
To confirm the timer time setting
Press the DISPLAY button.
To cancel the setting of timer recording
Press the DISPLAY button once or more so that “REC”
flashes on the display. While “REC” is flashing, press the
TIMER REC button.
*
Unless the AC supply lead is unplugged or there is a
power failure for more than 30 minutes, the time set on
the timer will be retained until it is reset.
Note
When the timer recording is finished, the timer setting is
automatically canceled to avoid repeating timer recording of
the same setting.
HOW TO USE THE BUILT-IN TIMER
Receiver
CD Player
DISPLAY TIMER
POWER
Tape Deck
4 4 1
TIMER REC
INPUT
RESUME