Setting the clock, E-13 english – Yamaha CC-50 User Manual

Page 15

E-13

English

While the power is on, press the DISPLAY button to
display the time. If the power is off, you can proceed to the
next step.

While pressing the TIME ADJUST button, press the
HOUR button and set the hour.
*

Press the HOUR button once to advance the time by 1
hour. Press and hold to advance continuously.

While pressing the TIME ADJUST button, press the
MINUTE button and set the desired time.
*

Press the MINUTE button once to advance the time by
1 minute. Press and hold to advance continuously.

The hour setting will not advance even if the minute
advance from “59” to “00”.

To display the time by “second”
While pressing the SEC button, the current time is displayed
by minute and second.

To reset the second to “00”
While pressing the SEC button, press the TIME ADJUST
button.
* If the current second is lower than 30, it is reset to 00.
* If the current second is higher than 30, the minute is

advanced by 1 minute and the second is reset to 00.
(If the current minute is “59”, in this case, the hour is also
advanced by 1 hour.)

In the event of a power failure or when the AC supply
lead is disconnected.
The time display will go out, however, the clock will function
for about 30 minutes without power supply. So you do not
have to reset the time if the AC power supply is resumed
within about 30 minutes.
When the AC power supply is resumed after more than 30
minutes pass without power supply, the time display will flash
on and off to indicate that the time must be reset.

Note
If this system is left for several minutes without setting the
time after the AC power lead of this system is connected to
the AC outlet, there may be a case that the display is turned
into a demonstration mode. (This mode is virtually
unnecessary for using this system.)
In this case, first turn the power on by pressing the POWER
switch to cancel the mode, and then set the time.

DISPLAY

MEMORY

TIME ADJ

DOWN

TUNING

HOUR

MINUTE