Yamaha CC-50 - Manual (Page 41)

E-39
English
➂
At ON TIME/time setting mode
[“ON TIME” appears on the display, and soon it is
changed to a time setting mode.]
Set to the time when the timer play begins by using
the HOUR button and the MINUTE button.
➃
At OFF TIME/time setting mode
[“OFF TIME” appears on the display, and soon it is
changed to a time setting mode.]
If necessary, set to the time when you want to finish
the timer play (to turn this unit off) by using the HOUR
button and the MINUTE button. Even if you do not set
the time, it has already been set so that the timer play
finishes after 1 hour.
* The TIMER button functions also in the time (ON
TIME or OFF TIME) setting mode.
3
If you will not use this unit until the timer play begins, turn
the power off by pressing the POWER switch or the
TIMER button.
Note
If a timer play setting is made and the power is not turned off,
the source set for the timer play will begin playing when the
time comes in place of the source played at that time.
To cancel the timer play setting
After the timer play is finished, press the DISPLAY button to
call the current time. While the current time is displayed,
press the TIMER button so that “TIMER” goes out from the
display.
If it is not canceled, the system will be turned on at the same
time every day, so it can be used as an alarm. However, if
you will be out at that time, cancel the timer play setting.
*
Unless the AC supply lead is unplugged or there is a
power failure for more than 30 minutes, the time set on
the timer will be retained until it is reset.
How to make time setting in the ON TIME or OFF
TIME mode
For the hour:
Press the HOUR button to change the hour to a higher value.
Press and hold to change continuously.
To change the hour to a lower value, while pressing the TIME
ADJUST button, press the HOUR button.
For the minute:
Use the MINUTE button and operate it in the same way as
you did to change the hour.
HOW TO USE THE BUILT-IN TIMER
POWER TIME ADJ
Receiver
DISPLAY TIMER
2- ➂ , ➃