Xantrex Technology 10 - Manual (Page 18)

Installation
2–2 975-0251-01-01
Installation Precautions
Application Information The Freedom 10 is provided with integral electronic
protection against AC and DC overloads.
Appropriate Applications
The Freedom 10 is appropriate for installation in recreational vehicle (RV),
residential solar installations, and marine applications. The installation
instructions for each application will be discussed separately. Refer to the separate
installation guide for typical installation examples.
WARNING: Fire or explosion hazard
This equipment is not ignition protected and employs components that tend to produce
arcs or sparks. To reduce the risk of fire or explosions, do not install in compartments
containing batteries or flammable materials or areas in which ignition-protected
equipment is required.
WARNING: Shock hazard and equipment failure
To reduce the risk of electric shock and prevent premature failure due to corrosion, do not
mount where exposed to rain or spray.
WARNING: Fire hazard
To prevent fire, do not obstruct ventilation openings. Do not mount in a zero clearance
compartment—overheating may result.
WARNING: Shock hazard
For continued protection against risk of electric shock use only the residual current circuit
breaker (RCCB) type receptacles. Other types may fail to operate properly when
connected to this inverter, resulting in a potential shock hazard.
WARNING: Shock hazard
Both AC and DC voltage sources are teminated inside this equipment.
Each circuit must be individually opened before servicing. When a solar array is exposed
to light it supplies DC voltage to the battery and this equipment.
WARNING: Shock hazard
Do not remove cover—no user serviceable parts inside. Refer servicing to qualified
service personnel.
Important: The output of this device is not sinusoidal. It has a maximum total
harmonic distortion of 47% and a maximum single harmonic of 34%.