Control panel – Yamaha DPX-1 User Manual
Page 6
E-
3
INTR
ODUCTION
English
1
indicator (P.14)
2 STANDBY/ON button (P.10)
Secondary power button
Turns on and sets this unit in the standby mode. This button is
effective only when the primary power switch is turned on.
Standby mode
In this mode, this unit consumes a small amount of power to
receive infrared siganls from the remote control.
3 LAMP/COVER indicator (P.14)
4 TEMP/FAN indicator (P.14)
5 FILM indicator (P.14)
6 INPUT button (P.11)
Turns on and off the menu to select the input terminal and the
input signal.
■ Control panel
Controls and functions
SELECT
ESCAPE
INPUT
STANBY/ON
FILM
MENU
PATTERN
TEMP
/FAN
LAMP
/COVER
STANDBY/ON
PATTERN
MENU
INPUT
LAMP
/COVER
TEMP
/FAN
FILM
ESCAPE
SELECT
DIGIT
AL CINEMA PROJECTOR DPX–1
1
2
3 4 5
6 7
8 9
0
q
Rear remote control
sensor
Ventilation (intake) slots / filter
covers
AC inlet
To plug in the supplied power cord.
Power switch
Primary power switch.
“ ” turns on and sets this unit in the
standby mode.
“ ” turns off this unit.
Adjusters
To fine-adjust the projection angle
Control panel
7 PATTERN button (P.10)
Turns on and off the stored test patterns on the screen.
8 MENU button (P.18)
Turns on and off the menu to set or adjust the parameters
necessary for projection.
9 ESCAPE button (P.18)
Closes the submenu.
0 Cursor buttons (P.18)
Used for the operation of h, g, –, and +.
q SELECT button (P.18)
Confirms the new setting entry, or opens the submenu.