Yamaha DPX-1 - Manual (Page 11)

E- 8
• Before making connections, make sure that the power of this unit and other components is turned off.
• Some components require different connection methods and have different jack names. Refer to the operation instructions for each
component to be connected to this unit.
• Plug in this unit correctly to prevent from creating noise or troubles.
■ Connecting a video component
There are five types of video connections available on this unit for A/V components as shown in the illustration below. Connect video output
signals from A/V components to this unit by following the illustration below with the correct cables and adapters.
◆ Note ◆
• When connecting A/V component to INPUT A component jacks, make sure to match the Y/P
B
/P
R
or Y/C
B
/C
R
of the A/V component and this unit to be
connected. Also refer to the operation instructions for the A/V component. HD/SYNC and VD need to be connected for RGB video signals in some cases.
CONNECTION
How to connect
Input
VIDEO
S VIDEO
INPUT A
INPUT B
D4 *
Type of signal
Composite video
S video
Component video/RGB video
Component video/RGB video
Component video
Type of jack
Pin jack
Mini DIN jack
BNC jack x 3—5
D-Sub 15-pin connector
D4 connector
RS-232C
DVI TRIGGER OUT
RGB/YP B P R /YC B C R
D4 VIDEO INPUT A
INPUT B VIDEO S VIDEO
VD G/Y R/P R /C R HD/SYNC B/P B /C B
G/Y R/P R /C R B/P B /C B
Video pin cable
S video cable
Converting plug
Pin cable
BNC cable for
component D connector cable
D-Sub monitor cable
Video
output jack
S video
output jack
Component/RGB video output
jack/connector
D1—D4 output
connector
Video outputs of various A/V components
D-Sub BNC jacks Pin jacks
* This connector is designed for the Japanese D format only.