Re-recording track 1 partially, Procedure – Yamaha CLP-970C EN User Manual
Page 44
44
CLP-970
Re-recording TRACK 1 partially
This section explains how to record part of a song again.
Procedure
If the playback screen is not
displayed, press one of the
SONG SELECT
[
] [
]
buttons once.
1.
Pause the song at the beginning of the part you wish
to re-record.
Use the B [–]/[+] buttons while the playback screen is dis-
played to move through the measures or play back the
recording and press the [START/PAUSE] button to locate a
point slightly prior to the beginning of the part you wish
to re-record.
2.
Select a voice or voices for recording, if necessary.
Repeat Step 2 on page 42 if you wish to change the previ-
ous settings.
3.
Select the recording method and enter record mode.
3-1
Press and hold down the [REC] button, and press the
C [–]/[+] buttons repeatedly to specify how the
recording should start and press the D [–]/[+] buttons
repeatedly to specify how the recording should end.
While you are holding down the [REC] button, the following record-
ing method select screen appears.
Starting methods:
Norm (Normal) — The existing data will be erased after re-recording
starts.
Key On — Data that exists prior to the point where you start playing a
note will not be erased.
NOTE
A
B
C
D
NO
YES
Playback screen
A
B
C
D
NO
YES